Labeling Speed
Up to 1500 linear inches per minue and, depending on label and product size,
approximately 350 per minute. Higher speeds available upon request.
Label Placement
Label placement up to +/- 1/32" when labels are produced to specifications
and product handling is controlled
Label Roll Size
12" maximum outside diameter wound on a 3" I. D. core. Die-cut waste removed
with minimum of 1/8" separations between labels in running direction.
Label Size
Minimum 1/2" wide x 1/2" long Maximum 6½" wide x 12" long (optional sizes
available)
Application Method
Tamp, wipe-on, flag, blow, corner-wrap, and swing tamp
Drive System
Servo motor |
Interface Sensors
Product sensor - photo eye/limit switch/PLC input Auxiliary outputs with
connector standard
Electrical
115 VAC/60Hz - 250 W idle, 600 running
Air Requirements
80 psi/3cfm when equipped with tamp, blow, swing, or corner-wrap
Environment Operating
50-95° F (10-35° C) 15-85% RH, non-condensing
General Size
25" W x 22" D x 21" H
Weight
60 lbs. with u-arm
Options
Touch screen, alarm beacon, low label, broken web, power unwind for larger
spools, left-hand models, custom programming |
